Diving bell is a rigid chamber used to transport divers from the surface to depth and back in open water, usually for the purpose of performing underwater work.
| FactSnippet No. 2,399,621 |
Diving bell is a rigid chamber used to transport divers from the surface to depth and back in open water, usually for the purpose of performing underwater work.
| FactSnippet No. 2,399,621 |
Unlike a submersible, the diving Wet bell is not designed to move under the control of its occupants, nor to operate independently of its launch and recovery system.
| FactSnippet No. 2,399,622 |
Wet bell is a structure with an airtight chamber which is open to the water at the bottom, that is lowered underwater to operate as a base or a means of transport for a small number of divers.
| FactSnippet No. 2,399,623 |
The Wet bell is mated with the chamber system via the bottom hatchway or a side hatchway, and the trunking in between is pressurized to enable the divers to transfer through to the chamber under pressure.
| FactSnippet No. 2,399,624 |
In saturation diving the Wet bell is merely the ride to and from the job, and the chamber system is the living quarters.
| FactSnippet No. 2,399,625 |
Third type is the rescue Wet bell, used for the rescue of personnel from sunk submarines which have maintained structural integrity.
| FactSnippet No. 2,399,626 |
Diving Wet bell is one of the earliest types of equipment for underwater work and exploration.
| FactSnippet No. 2,399,627 |
Diving Wet bell is mentioned in the 1663 Ballad of Gresham College :.
| FactSnippet No. 2,399,628 |
The Wet bell is ballasted so as to remain upright in the water and to be negatively buoyant, so that it will sink even when full of air.
| FactSnippet No. 2,399,629 |
Physics of the diving Wet bell applies to an underwater habitat equipped with a moon pool, which is like a diving Wet bell enlarged to the size of a room or two, and with the water–air interface at the bottom confined to a section rather than forming the entire bottom of the structure.
| FactSnippet No. 2,399,630 |
Wet bell is a platform for lowering and lifting divers to and from the underwater workplace, which has an air filled space, open at the bottom, where the divers can stand or sit with their heads out of the water.
| FactSnippet No. 2,399,631 |
Gas panel inside the Wet bell is supplied by the Wet bell umbilical and the emergency gas cylinders, and supplies the divers' umbilicals and sometimes BIBS sets.
| FactSnippet No. 2,399,632 |
Abandonment of a type 2 wet bell requires the divers to manage their own umbilicals as they ascend along a remaining connection to the surface.
| FactSnippet No. 2,399,633 |
The Wet bell is lowered into the water and to the working depth at a rate recommended by the decompression schedule, and which allows the divers to equalize comfortably.
| FactSnippet No. 2,399,634 |
The requirement that the Wet bell retain its internal pressure when the external pressure is lowered dictates that the hatch open inward, so that internal pressure will hold it closed.
| FactSnippet No. 2,399,635 |
The Wet bell umbilical is connected to the Wet bell via through hull fittings, which must withstand all operating pressures without leaking.
| FactSnippet No. 2,399,636 |
Once cut, the Wet bell can be raised and if the umbilical can then be recovered, it can be reconnected with only a short length lost.
| FactSnippet No. 2,399,637 |
The Wet bell handling system is known as the launch and recovery system.
| FactSnippet No. 2,399,638 |
The Wet bell umbilical is deployed from a large drum or umbilical basket and care is taken to keep the tension in the umbilical low but sufficient to remain near vertical in use and to roll up neatly during recovery, as this reduces the risk of the umbilical snagging on underwater obstructions.
| FactSnippet No. 2,399,639 |
The clump weight cables therefore act as guidelines or rails along which the Wet bell is lowered to the workplace, and raised back to the platform.
| FactSnippet No. 2,399,640 |
The Wet bell is released and locked onto the cursor in the relatively still water below the splash zone.
| FactSnippet No. 2,399,641 |
The diving Wet bell would be connected via the mating flange of an airlock to the deck decompression chamber or saturation system for transfer under pressure of the occupants.
| FactSnippet No. 2,399,642 |
Air lock diving-Wet bell plant was a purpose-built barge for the laying, examination and repair of moorings for battleships at Gibraltar harbour.
| FactSnippet No. 2,399,643 |
The closed dry Wet bell is designed to seal against the deck of the submarine above an escape hatch.
| FactSnippet No. 2,399,644 |
The internal pressure in the Wet bell is usually kept at atmospheric pressure to minimise run time by eliminating the need for decompression, so the seal between the Wet bell skirt and the submarine deck is critical to the safety of the operation.
| FactSnippet No. 2,399,645 |
Diving Wet bell spider, Argyroneta aquatica, is a spider which lives entirely under water, even though it could survive on land.
| FactSnippet No. 2,399,646 |